Book Errata

Engineering Graphics Essentials with AutoCAD 2019 Instruction

Text and Video Instruction

Out of Print
Published August 7, 2018
946 Pages
ISBN: 978-1-63057-191-7

Errata

Chapter 2 Page 2-133

Question 2-3 should read as follows:

Q2-3) The Key(s) that allow you to quickly repeat your last command. (Choose all that apply.)

a) space bar
b) esc
c) tab
d) enter
Chapter 4 Page 4-25

You are instructed to open the base drawing and then immediately do a "Save As" to the block name. This causes an error at the end when you try to "WBLOCK" with the same name. Please omit the first instruction to "Save As" at the beginning to prevent this from happening.

Chapter 4 Page 4-27

You are instructed to open the base drawing and then immediately do a "Save As" to the block name. This causes an error at the end when you try to "WBLOCK" with the same name. Please omit the first instruction to "Save As" at the beginning to prevent this from happening.

Chapter 4 Page 4-28

In Number 6), part d) "Block Definition Window" sub item vi. It states "Set the Block Units to Inches" should read "Set the Block Units to Millimeters".