https://www.sdcpublications.com/Textbooks/Technical-Drawing-101-AutoCAD-2023/ISBN/978-1-63057-499-4/Errata/A list of the know errors for the book Technical Drawing 101 with AutoCAD 2023.Tue, 14 Apr 2026 10:16:07 -0500http://www.rssboard.org/rss-specification824https://static.sdcpublications.com/images/common/logo_rss.pnghttps://www.sdcpublications.com/Textbooks/Technical-Drawing-101-AutoCAD-2023/ISBN/978-1-63057-499-4/Errata/14454SaturdaySunday<p> Floor Plan Checklist. The seventh bullet from the top says there are twenty 120VAC outlets, but there are actually <strong>twenty-one</strong>. </p> https://www.sdcpublications.com/Textbooks/Technical-Drawing-101-AutoCAD-2023/ISBN/978-1-63057-499-4/Errata/<p> Step 6c. should say: "Refer to Figure CP2.42(a) to array the two new roof lines using the <strong>Rectangular Array command</strong>." </p> https://www.sdcpublications.com/Textbooks/Technical-Drawing-101-AutoCAD-2023/ISBN/978-1-63057-499-4/Errata/ <p> Question three should have four possible answers. What is listed as answer "e." in the book should be the start of question four with the possible answers listed below it. Below are how the questions should appear in the book: </p> <ol start="3"> <li> What is the angle of an object’s vertical lines in an isometric drawing? <ol style="list-style-type: lower-alpha;"> <li>90°</li> <li>45°</li> <li>30°</li> <li>60°</li> </ol> </li> <li> On which tab in the Drafting Settings dialog box is the Rectangular snap button located? <ol style="list-style-type: lower-alpha;"> <li>Snap and Grid tab</li> <li>Polar Tracking tab</li> <li>Dynamic Input tab</li> <li>Object Snap tab</li> </ol> </li> </ol> <p>What is listed as question four in the book, should now be question five.</p>https://www.sdcpublications.com/Textbooks/Technical-Drawing-101-AutoCAD-2023/ISBN/978-1-63057-499-4/Errata/