SDC Publications: SOLIDWORKS 2019 Intermediate Skills Book Errata

Chapter 2 Page 12

To get the cut necessary to get the final part to look the same and get the same mass, set the height of the left rectangle to 0.185" above the center-line.

Chapter 3 Page 3

Step 1, the text should indicate "select the Right plane" instead of "select the Front plane".

Chapter 5 Page 16

Step 6. The second to last paragraph and corresponding image should instruct you to "select the face in the back of the large flange" instead of the face on the far side of the small flange. Throughout the rest of this chapter images show the threads going all the way through the feature.

Chapter 5 Page 17

Step 6 should say Inch-Tap not Inch-Die.

Chapter 6 Page 14

Step 2. continued from the previous page. At the top of the page the figure and instructions indicate that you should select 3 edges to keep fixed, but this is not correct. You should only select one edge, the bottom back edge to keep fixed. See the image below.

Chapter 8 Page 26

Step 3. Making the sketch of the tip. The first sentence should say: "Open a new sketch on the Right plane."

Chapter 15 Page 15

The 3rd sentence on page 15-15 should say: Click the Model Found Here option, not Current Document option.

Chapter 17 Page 23

Due to changes in the Adobe Acrobat app, pages 23 - 26 have been updated. They may be downloaded here: Chapter 17, Pages 23-26

Chapter 18 Page 8

The 3rd paragraph says: "Repeat the same steps to ensure both corners are identical with each other."

It should read: "Repeat the same steps to ensure both sides are identical with each other."