SDC Publications: SOLIDWORKS 2018 Intermediate Skills Book Errata

Chapter 2 Page 3

Step 1. Should say - Select the Right plane (not the Front plane).

Step 6 and 11 - Offset dimension in the dialog boxes should be .040” to match with instruction.

Thread is through all. Use the surface in the back of the large flange.

This page says to select the 3 edges. You should only select the opposing single edge.

Step 20 should say - Click the Flip-Offset checkbox to place the new plane below the face.

Step 22. The Concentricity is between the .129 Thru Hole and the .266 Bore Hole.

The 3rd paragraph says: "Repeat the same steps to ensure both corners are identical with each other."

It should read: "Repeat the same steps to ensure both sides are identical with each other."