SDC Publications: Residential Design Using Autodesk Revit 2021 Book Errata

Chapter 0 Page viii

The Bonus Videos Index contains an entry for "7-3 Sloped Ceiling." This video is not available. It was mistakenly included in this list.

Chapter 1 Page 41

Autodesk has replaced Autodesk 360 (A360) with Autodesk Drive. The functionality covered in the book is similar in Autodesk Drive. Following the links provided in the book will provide you with a link to the new site. Alternatively, use this link to access Autodesk Drive: https://drive.autodesk.com/

Chapter 5 Page 44

Step 12.d calls for creation of wall openings of 80" (6' 8"). Figure 5-4.9 indicates the wrong dimension. Below is the correct image.

Chapter 5 Page 53

Figure 5-5.2 incorrectly displays the chimney dimensions as 6'-2", when they should be 5'-8". See the revised image below.

Chapter 6 Page 4

The second paragraph should read:

The two walls just drawn will be supported by the roof, which has not been drawn yet. The bottom of the walls is aligned with Level 2 because of the view you are in.

Chapter 6 Page 24

The second paragraph says the “UP” label in Figure 6-5.3 indicates where you should access the stair on the first floor. The "UP" label is not present on the image as described in the book. The image below contains the "UP" label.

Chapter 10 Page 10

Last paragraph should specify 12'-3" as the dimension which will center the windows on the wall, as shown in figure 10-2.2.

Chapter 10 Page 12

The paragraph after step 13. Should read: Why did the window location dimensions update in Figure 10-2.2 and not in Figure 10-2.5?

Chapter 11 Page 3

Step 8, paragraph 3 Should state, "You may also notice a big problem, as first mentioned on page 6-33…".

Chapter 11 Page 26

Figures 11-4.2 and 11-4. should show the dimension as 3'-10". The corrected figures are available about below.

FIGURE 11-4.2 Selected dimension properties

FIGURE 11-4.3 Dimension with suffix