SDC Publications: Parametric Modeling with Autodesk Inventor 2013 Book Errata

Chapter 4 Page 4-25

Exercise 4-3: There is a missing dimension on the front face (length of bottom of face)in the book. The missing dimension should be 3". This is the corrected image:

Chapter 5 Page 5-30

Exercise 1: Swivel base. The radius should be 0.25 for the two rounded corners.

Chapter 14 Page 14-36

The size of chamfer for (b) connector should be 1/16 x 45 degrees.

Chapter 14 Page 14-38

The size of chamfers for (f) & (g) should be 1/16 x 45 degrees.

Chapter 14 Page 14-35

The exercise on this page was missing a dimension needed to complete the drawing. This is the corrected image.

Chapter 16 Page 16-28

Exercise 2. The height of the small end of the bracket (stop) of the hanging bracket should be 2 inches.