SDC Publications: Interior Design Using Autodesk Revit 2014 Book Errata

Chapter 1 Page 1-29

The first paragraph on page 1-29, after step #9, should be changed to “This will close the current project. If more than one view is open for a project, they will all be closed.“

Chapter 6 Page 6-47

Below is an updated image with the correct room name and number.

Chapter 8 Page 8-14

Step 8: change Actual Run Width to 4’-0” (was 3’-0”.

Chapter 8 Page 8-25

Step 69: change to: Click OK, also click OK or Delete Type if prompted.

Chapter 9 Page 9-20

The profile is called out to be 5/8" x 4-7/8", however, the profile should be called out as 5/8" x 3-5/8".

For a more comprehensive explanation of why this change was made please refer to the article, Soffit and Bulkhead Modelling in Revit, written by Dan Stine, one of the authors of this book.