SDC Publications: Engineering Graphics Tools for the Mind Book Errata

Chapter Lettering Page Exercise 5

In Exercise LTR-5, in the bottom image, the circle on the right side of the part does not line up on the top and front views. Your answers for the dimensions of this feature should be based on the top view.

Chapter Sections Page 1

SEC-3 The notch on the rear of the rectangular tower in the Full Section Isometric was not shown. Below is a corrected image.

Chapter Dimensioning Page 2

DIM-3This revised illustration shows the overall dimensions.

Chapter Dimensioning Page 2

DIM-5 This correct illustration replaces the incorrect DIM-5.

Chapter Sections Page 3

SEC-7 The middle circle in the Front View should be a hidden line. Below is a corrected image.