SDC Publications: Engineering Analysis with SolidWorks Simulation 2013 Book Errata

Chapter 10 Page 185

Under the project description it should read: The temperature of the entire loop shown in Figure 10-1, increases uniformly from an initial 298K to 500K.

Chapter 14 Page 254

Caption in italics under illustration 14-23 should say:
A linear model cannot distinguish between the two configurations shown in this illustration.

Chapter 20 Page 423

Figure 20-27 The Z coordinate of load application point in the global coordinate system should be 400mm not 414mm Note: make the same change to the 02 short study in the downloadable model PIPES.SLDASM