SDC Publications: Engineering Analysis with SolidWorks Simulation 2012 Book Errata

Chapter 10 Page 181

Fifth line from the top should say:
(detail in Figure 10-8)

Chapter 11 Page 183

Under the project description it should read: The temperature of the entire loop shown in Figure 11-1, increases uniformly from an initial 298K to 500K.

Chapter 15 Page 252

Caption in italics under illustration 15-23 should say:
A linear model cannot distinguish between the two configurations shown in this illustration.

Chapter 15 Page 252

Caption in italics under illustration 15-23 should say:
A linear model cannot distinguish between the two configurations shown in this illustration.

Chapter 19 Page 349

Call-out in Figure 19-20 should say:
10mm displacement in normal direction to the Top Plane which is the y direction shown in Figure 19-19

Chapter 21 Page 407

Figure 21-27 The Z coordinate of load application point in the global coordinate system should be 400mm not 414mm. Note: make the same change to the 02 short study in the downloadable model PIPES.SLDASM

Chapter 21 Page 408

Figure 21-28 The maximum von Mises stress should be 504MPa not 522MPa.