SDC Publications: Design Integration Using Autodesk Revit 2019 Book Errata

Chapter 1 Page 41

Autodesk has replaced Autodesk 360 (A360) with Autodesk Drive. The functionality covered in the book is similar in Autodesk Drive. Following the links provided in the book will provide you with a link to the new site. Alternatively, use this link to access Autodesk Drive: https://drive.autodesk.com/

Chapter 5 Page 11

Step 3, first paragraph: The end of the last sentence should direct you to see Figure 2-1.4.

Chapter 6 Page 43

In figure 6-4.9 The 5th layer material should be Gypsum Ceiling Board, not Gypsum Wall Board.

Chapter 7 Page 65

Step #18 should be changed to set Use Top Rail to No.

Chapter 8 Page 62

Step 29, should say to switch to B.O Footing plan view.

Chapter 8 Page 64

Figure 8-5.8 isn't correct image for the Type Properties Dimensions Parameter. Below is the correct image.

Chapter 11 Page 24

Step 2a: These files have been removed by Autodesk for this version of Revit. We have made these files available in the exercise files download for this book.

Chapter 14 Page 3

The paragraph approximately halfway down the page references Figure 14-2.6 when it should reference Figure 13-2.6.