SDC Publications: Design Integration Using Autodesk Revit 2018 Book Errata

Chapter 5 Page 11

Step 3, first paragraph: The end of the last sentence should direct you to see Figure 2-1.4.

3a) Curved wall radius is incorrect. Radius SHOULD read 26'-6", NOT 26'-0". Should look like the radius in Figure 5-2.2

The second paragraph, first sentence should start out reading: "Back on page 5-18 and following you explored the exterior wall style."

In figure 6-4.9, the Material listed in layer 5 should say "Gypsum Ceiling Board". See the updated screenshot below.

Step #18 should be changed to set Use Top Rail to No.

Figure 8-5.8 isn't correct image for the Type Properties Dimensions Parameter. Below is the correct image.

The paragraph approximately halfway down the page references Figure 14-2.6 when it should reference Figure 13-2.6.

Lesson 18, self exam question 1 has the wrong answer listed in the book. The correct answer should be "T" and not "F".