SDC Publications: Commercial Design Using Revit Architecture 2009 Book Errata

Chapter 2 Page 19

Fig. 2-2.3 is the wrong image. Replace with this image.

Fig. 3-2.7: Change the material column, in the last row, from “Finishes-Interior-Gypsum wall Board” to “Gypsum Wall Board”

In the “FYI” Box, in the second sentence, replace “on” with “one”.

Fig. 3-3.7: (same change as pg. 3-7 above).

Step 22 “Tip”: change “select the wall” to “select the door”.

First paragraph: Change all the instances of “group” to “family”.

Step 3: Change “group” to “family”.

Step 3: Change “Troffer – 2x4 parabolic.rfa” to “Troffer Light-2x4 parabolic.rfa”.

Step 6 (same as previous step).

Paragraph before step 11: Change “step 9” to “step 10”.

Step 13: Change “click” to “Clip”.

Bold text: Change “Far clip active” to “Far Clipping”.

Gray box: Change “non-drawn” to “not drawn”.

Step 22: Change “OK” to “Close”.

Step 23: Change “Broswer” to “Browser”.

Sentence at top of page: Omit “(Figure 7-6.18)”.

Review questions #5: Omit “(width)”.

Review question 7: Change “line” to “lines”.

Step 14: Change “ex10-2.rvt” to “ex10-1.rvt”.

Paragraph before step 15: Change “where” to “were”.

Step 5: Change “Dynamically modify view” to “view cube”.

Step 17: Change “accurender” to “render appearance”.

Review question #`1: Question no longer applies; omit.