SDC Publications: CSWE - Certified SolidWorks Expert Preparation Materials Book Errata

Chapter 1 Page 4

Step number 3 should read "Measure the angle between the RIGHT plane and the center axis of the handle".

After completing step number 3, remember to press Rebuild (Control + B) to force an update on all parts within this assembly.

Step number 4, the note on the lower left hand should say: Select this face for Direction of Pull (instead of select the 6 faces for parting Lines).

Step number 2 should say: Select the Top plane and open a new sketch (instead of select the Front plane and open a new sketch).

Step number 2, the note at the bottom left of the image should say: Coincident to the Ø1.750 - Not Coincident to the Origin.

Step number 8, the note should say: Change to 60° (instead of Change to 45°).