SDC Publications: Beginner's Guide to SOLIDWORKS 2025 - Level I Book Errata

Chapter 1 Page 15

Step 1.13 should direct you to go to the menu "Tools, Options, Document Properties", as shown in the corresponding image, instead of Document Options.

Chapter 2 Page 161

Exercise 8. The shell thickness dimension is missing from the provided figures. It should be .125".

Chapter 3 Page 338

Step 16.9, The second sentence should read, "If the path had been a straight line, a "Cute Extrude" would produce a similar result."

Chapter 3 Page 346

The fillet radius of the four inside bosses located on the underside of the top of the Crank Case are missing. Please use the corrected image below.

Chapter 6 Page 769

Step 34.7, the second paragraph should read "... enter a value of 2,500 lbf..." instead of 1,500 lbf. Images on pages 770, 775, 781 should also read 2,500 lbf.