SDC Publications: AutoCAD Civil 3D 2017 Fundamentals Book Errata

Chapter 4 Page 4

The first bullet point read: "In the Figure Style dialog box..."

The title of the window shown in Figure 4-1 should also ready "Figure Style".

Chapter 4 Page 39

#3 says to ..."expand the Format Drop-down list..." No drop-down list exist for this section.

Chapter 4 Page 57

#4 says to "...select the Include all points option, and set it to True." There is no selection of "True" capability. This can be ignored.

Chapter 5 Page 1

The fifth bullet point should read "Add breaklines and boundaries to a surface to improve its accuracy."

Chapter 5 Page 11

The second paragraph should read "If there are more than 15...".

Chapter 5 Page 20

Instruction #4 says, "...and type Contours 2' and 10' Background..." This is a drop-down field and should ask you to select those dimensions.

Chapter 5 Page 29

"3. In the contextual Surface tab>..." This is the Tin Surface: ExTopo contextual tab.

Chapter 5 Page 85

#2 was already achieved in #1 and cannot be achieved again because the dialog box is now active from the second part of #1.

Chapter 6 Page 16

In the first paragraph the fourth sentence should say: The north center line leg is 353.17’ to the point of intersection .

Chapter 10 Page 48

Task 2 #1 needs added to with; Modify tab> Design panel dropdown> Pressure Pipe Network tab> Modify panel> Edit Network dropdown> Plan Layout Tools> Select Water then OK.

Chapter 10 Page 49

#3 needs "push" added to the "tee-12 in x 10 in push on ductile iron" fitting description.