SDC Publications: AutoCAD 2017 Tutorial First Level 2D Fundamentals Book Errata

Chapter 1 Page 34

Step 3. The second sentence should say to left-mouse-click to select the location as the center point of the new arc.

Chapter 2 Page 6

17. Move cursor toward the right side...

Chapter 2 Page 32

Exercise #4 Sensor Mount. The line of 1.5 inches which is 2.25 inches above the base line of the drawing is incorrect and unnecessary.

Chapter 3 Page 27

Step 6. should direct you to select the Center-Radius command icon in the Draw toolbar.

Chapter 3 Page 44

The original image was missing the diameter of the circle. Please use this revised image.

Chapter 4 Page 9

The first paragraph should say:

Note that in the Elements section, all the line elements are listed in descending order with respect to their offsets. We will create two line elements representing a five-inch wall (offsetting on both sides of the reference location). sides of the reference location).

Chapter 5 Page 31

There is a 30 degrees dimension missing for the drawing in the book. The following image is correct.

Chapter 7 Page 14

Step 2. The original image had the incorrect labels on the image. See the revised image below.